Setting The Sdi Output Mode; Setting M/E Dedicated Outputs - Sony XVS-9000 User Manual

Setting the SDI Output Mode

When an XKS-S8167 12G-SDI Output Board is installed
in the XVS-8000/7000/6000, you can set the output mode
of 3840×2160P 2SI (Level A) format signals.
Select 12G mode or 3G mode for each group of four output
connectors assigned to 4K signals. In 12G mode,
3840×2160P 2SI (Level A) format signals are output as a
12G×1 signal. In 3G mode, they are output as 3G×4
signals.
Notes
• This setting is available only when the switcher signal
format is 3840×2160P.
• When the switcher signal format is 3840×2160P SQD,
this setting is available only for format converter output
connectors and spare connectors.
1
In the Engineering Setup >Switcher >Output menu
(7333), press [SDI Mode].
The SDI Mode menu (7333.19) appears.
2
In the status area, select the target output connector
group to set.
To select all groups, press [ALL].
To select multiple groups, set the number using the
[Num] parameter. The specified number of groups are
selected from the currently selected group.
3
In the <SDI Mode> group, select the SDI output mode.
12G: Set to 12G mode.
3G: Set to 3G mode.
To clear the output mode setting
Press [Clear].
4
Press [Execute].

Setting M/E Dedicated Outputs

On the XVS-8000, four M/E dedicated outputs are
supported when the switcher signal format is 3840×2160P.
Note
To use M/E dedicated outputs, an XKS-S8165 SDI Output
Connector Board must be installed in slot 2 of the switcher.
Setting the Ext Out mode
You can enable either the M/E dedicated output or DME,
since they use the same output (Ext Out) on each switcher
bank.
By default, Ext Out is configured for DME use. To enable
M/E dedicated output, Ext Out must be configured for
M/E dedicated output use.
Notes
• The Ext Out mode setting is common to all the M/E and
PGM/PST banks.
• If Ext Out is set for M/E dedicated output use, all
functions relating to DME effects (DME, DME wipe,
image effect) cannot be used in 4K format.
1
In the Engineering Setup >Switcher >Output menu
(7333), press [M/E Dedicated Out Assign].
The M/E Dedicated Output Assign menu (7333.8)
appears.
2
In the <M/E Ext Output Mode> group, select the Ext
Out mode.
DME: Use Ext Out for DME.
Dedicated Output: Use Ext Out for M/E dedicated
output.
Setting an Ext Out signal
You can configure two outputs (Ext Out1, Ext Out2) on
each switcher bank to use with M/E dedicated outputs. The
following signals assigned to Out1 to Out4 using the
Engineering Setup >Switcher >Config >M/E Output
Assign menu (7331.1) can be set as an Ext Out signal.
• Program outputs
• Preview output
• Clean output
• Key preview outputs
1
In the Engineering Setup >Switcher >Output menu
(7333), press [M/E Dedicated Out Assign].
The M/E Dedicated Output Assign menu (7333.8)
appears.
2
Press [M/E Ext Out Assign].
The M/E Ext Output Assign menu (7333.11) appears.
The status area shows the Ext Out list of each switcher
bank on the left and the selectable output signal list on
the right.
3
In the list on the left, select the target Ext Out to set.
4
In the list on the right, select an output signal.
5
Press [Set].
447