Freeze Settings - Sony XVS-9000 User Manual

Image 2: State with [Effect Gp1] only enabled
Portion 2 has
"Mono" masked,
and "Defocus"
only applied.
m
If [Effect Gp2] is enabled from image 2, then the mask
should be applied to portion 2 only, but in fact the border
or beveled edge is also masked.
Image 3: State with [Effect Gp1] and [Effect Gp2] enabled
The border or
beveled edge effect
is also masked.

Freeze Settings

The following types of effect are available to freeze the
input video.
Hard Freeze: Freezes the input video and pauses at an
arbitrary position.
Time Strobe: Freezes the input video and pauses at
specified intervals and duration.
Film: Frame advance effect like in movie films. You can
specify the frame advance rate.
Freezing using Hard Freeze
1
Open the DME >Freeze >Freeze menu (4131).
2
In the <Freeze Timing> group, select the freeze
timing.
Frame: Freeze the signal using frame units.
Field1: Freeze the first field of the signal.
Note
When the signal format is 3840×2160P 2SI, 1080P,
1080PsF, or 720P, the freeze timing cannot be
specified.
3
In the <Freeze> group, press [Hard Freeze], turning it
on.
Freezing using Time Strobe
1
Open the DME >Freeze >Freeze menu (4131).
2
In the <Freeze Timing> group, select the freeze
timing.
Portion 1
Frame: Freeze the signal using frame units.
has both
"Mono" and
Field1: Freeze the first field of the signal.
"Defocus"
applied.
Note
When the signal format is 3840×2160P 2SI, 1080P,
1080PsF, or 720P, the freeze timing cannot be
specified.
3
In the <Freeze> group, press [Time Strobe], turning it
on.
4
Set the following parameters.
No.
1
2
Freezing using Film
Note
When the signal format is 720P or 1080P, Film mode
cannot be selected.
1
Open the DME >Freeze >Freeze menu (4131).
2
In the <Freeze> group, press [Film], turning it on.
3
Set the following parameter.
No.
1
244
Parameter Adjustment
Duration Freeze interval
Live Proportion of time between frozen
images for inserting live video
Parameter Adjustment
Film Rate of film frame advance