Setting Wipe Modifiers - Sony XVS-9000 User Manual

Applying a diamond dust wipe effect to the
selected pattern
1
In the M/E-1 >Wipe >Pattern Mix menu (1152), press
[Dust Mix], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Mix Ratio Mix level of diamond dust pattern
2 H Size Particle width
3 V Size Particle height
4 Flash Rate Rate of generation of particles

Setting Wipe Modifiers

You can apply various modifiers to a wipe pattern, such as
setting the wipe direction and pattern position.
Note that some modifiers may not be available, depending
on the pattern (see page 148).
Main pattern and sub pattern modifiers
You can set the following modifiers independently for the
main pattern and sub pattern.
• Positioner
• Rotation
• Aspect
• Multi
• Pairing
• Modulation
• Spring
• Spiral
Modifiers for the main pattern are set in the M/E-1 >Wipe
>Main Modify menu (1155), and modifiers for the sub
pattern are set in the M/E-1 >Wipe >Sub Modify menu
(1156). The menu operations are common to both.
This section describes setting modifiers for the main
pattern as an example.
Setting the wipe direction (Direction)
Specify the direction of the wipe effect.
Normal
Wipe in the normal direction.
Reverse
Normal/Reverse
The wipe direction alternates between normal and reverse
after each transition.
To specify the wipe direction in the menu
1
Open the M/E-1 >Wipe >Edge/Direction menu
(1154).
2
In the <Direction> group, specify the wipe direction.
To specify the wipe direction using a button in the
transition control block
In the transition control block of each bank, press the wipe
direction selection buttons.
1)
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
1) When the [REV] button is not lit if using the transition control block
(simple type).
Splitting the wipe pattern (Split)
This splits the pattern, making the parts of the wipe move
in opposite directions.
Split disabled
1
Open the M/E-1 >Wipe >Edge/Direction menu
(1154).
2
Press [Split], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Split No
2 Spacing
142
Wipe in the opposite direction of
the normal direction.
Split enabled
Number of splits (1 to 4)
Spacing between adjacent patterns