Network Settings (Network Config Menu); Making The Network Settings - Sony MVS-8000 User Manual

Network Settings (Network Config Menu)

This provides automatic configuration of all devices connected to the Data
LAN (excluding the DCU), and displays a list of them.
To make the network settings, use System >Network Config menu.
To display the Network Config menu
In the Engineering Setup menu, select VF1 'System' and HF1 'Network
Config.'
The status area shows the device ID, and Control LAN and Data LAN IP
addresses for each device excluding the DCU.

Making the Network Settings

Checking IP address automatically
1
In the System >Network Config menu, press [Auto Config].
This automatically checks all devices (excluding the DCU) connected to
the Data LAN.
2
Once switch to another menu, then display the Network Config menu
again.
Now the status area of the System >Network Config menu shows the
results of the automatic check.
Notes
Be sure to carry out this operation after reconfiguring the system, or after a
software upgrade.
Using the NFS server
The address of the currently selected NFS server appears in the [NFS Server
Address] box in the lower status area.
Notes
When the control panel is reset, no NFS server can be used via the Network
Config menu. In this case, to use an NFS server, make sure to carry out the
following procedure.
Network Settings (Network Config Menu)
15