Table of Contents
Advertisement
Installing the server and peripheral devices
Connecting peripherals to the server
Rear panel connectors
The following diagram shows the connectors on the rear panel.
Label
A
RJ-45 Serial A Connector
B
Rear Video
C
Dual USB port
D
Dual USB port
E
ELAN
F
CLAN
G
HB1
H
Mirror
To connect the mouse, keyboard, and monitor to the server
1. Place the monitor, keyboard, and mouse in the same location as the server.
2. Plug the keyboard cable into the lower USB port labeled C and the mouse cable
3. Plug the monitor into the video connector on the rear panel. Tighten the screws on
4. Ensure that a single-point ground reference is available for all the power outlets
32
Avaya CallPilot® 1006r Server Hardware Installation
Control or feature
into the upper USB port labeled C on the rear panel (see Rear panel connectors).
the connector.
serving the CallPilot server and its peripherals. Before the CallPilot server
installation, a qualified electrician must implement the single-point ground reference
Label
Control or feature
I
Not connected
J
HB2
K
Power Receptacles
L
MPB96-1 DS30-3
M
MPB96-1 DS30-2
N
MPB96-1 DS30-1
December 2010
Advertisement
Table of Contents
