Projector Control Port; User-Supplied Communications Cables - Extron electronics System 8 Plus User Manual

im Vertrieb von
Cables

Projector Control Port

User-Supplied Communications Cables

15-PIN
HD FEMALE
Extron
System 8/10
Switcher
www.camboard.de
Extron • System 8/10 P
LUS
CAMBOARD Electronics
The projector control port is a 15-pin HD
connector located at the upper right
hand corner of the rear panel.
A Communications Cable (CC) is used
to connect the System 8/10 P
projector, or to a suitable
communications adapter. The cable is
CL-2 rated and is available in three
lengths, listed below.
Cable Length Extron Part Number
CC-50' 50 ft. 26-305-01
CC-100' 100 ft. 26-305-02
CC-200' 200 ft. 26-305-03
For custom installations, you may choose to make your own communications
cables. If so, be sure to use approved installation practices, such as:
• Installation requires plenum rated cables
• Cables will be run through conduit
If you wish to make your own communications cables (up to 200 feet in length),
using 26-AWG twisted pair cabling, follow the pin-to-pin wiring illustrated below.
The first illustration is for a Standard Communications cable with 15-pin male to
9-pin female connectors.
15-PIN
HD MALE
1
2
3
4
5
6
7
8
15
The second illustration is for a Type II Communications cable with 15-pin male to
15-pin female connectors. This cable is required for certain installations, for
example, when using the Ampro Type II adapter, etc.
Tel. 07131 911201
• User's Manual
Fax 07131 911203
Projector/Monitor Installation
to the
LUS
200 Ft (max)
D-SUB FEMALE
ce-info@camboard.de
9-PIN 9-PIN
D-SUB MALE
1
2
3
Extron
Communications
4
Adapter
5
6
7
8
9
3-2