Stand Alone Operation; Address Switch Settings; Configuration Setup; Removing The Access Cover - Extron electronics System 8 Plus User Manual

im Vertrieb von
Projector/Monitor Installation
15-PIN
D-SUB FEMALE
Ampro
HOST
connector

Stand Alone Operation

Address Switch Settings

Configuration Setup

Removing the Access Cover

_____ Do NOT touch the IC chips!
www.camboard.de
3-3
CAMBOARD Electronics
200 Ft (max)
15-PIN
MALE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
If you plan to use your System 8/10 P
connected to a projector, it must be configured for RS-232 mode. The switcher
settings are shown on the following page.
For installations with one switcher, configure the System 8/10 P
switcher by setting the address switch on the rear panel. If multiple switchers are
being used in a master/slave configuration, refer to Chapter 5.
System 8/10 P switchers are shipped from the Extron factory configured for
LUS
the projector brand specified by the user at the time of the order.
Labels are placed in three locations:
1. On the shipping container
2. On the rear panel
3. Inside the front panel access cover lower left (See picture on next page.)
Switcher configuration is done with switch settings behind the front access panel.
Information is printed on a label inside the front panel access cover for setting up
most applications. The label includes a place for the user to mark the
configuration for which the System 8/10 P
This chapter covers the setup and installation of the System 8/10 P
specific projectors and displays. This includes instructions for changing the
configuration switches. If your application includes connecting more than one
switcher, you will also need to refer to Chapter 5.
If it is necessary to check or change any configuration switches, the Front Panel
Access Cover must be removed. This is done with a small, flat-blade
screwdriver.
Tel. 07131 911201
Fax 07131 911203
Comm Adapters
15-PIN 15-PIN
D-SUB FEMALE D-SUB MALE
1
2
3
Extron
Communications
4
Adapter
5 Type II
6
7
8
9
10
11
12
13
14
15
in a system where it will not be
LUS
is set.
LUS
ce-info@camboard.de
Extron • System 8/10 P
LUS
as a master
LUS
with
LUS
• User's Manual