Lus Lus; System 4 With One System 8/10 P - Extron electronics System 8 Plus User Manual

im Vertrieb von
Multiple Switcher Operation

System 4 with One System 8/10 P

Important audio
information! If balanced
audio connections are
made from the System 8/
10 P audio output to the
LUS
System 4 audio input,
there will be +6 dB of gain.
This gain can be offset with
a 6 dB pad. If the level of
gain does not exceed the
System 4 maximum input
level, the level can be
offset with the System 4
audio gain/cut menu.
However, if audio
connections are made
unbalanced, there is
no gain.
The audio
attenuator(s) on the
System 8/10 P
LUS
audio inputs should be
set to 0 dB cut by
turning the attenuator
clockwise until it stops.
This will set all input
audio levels on the
System 4. Refer to the
System 4 User Manual
for audio setup.
_____
www.camboard.de
5-7
CAMBOARD Electronics
Switcher
LUS
The System 8/10 P must be configured as a System 4 Slave. Connect the
LUS
RGBHV and Audio output of the System 8/10 switcher to the last (4th) input of
the System 4. Use the figure below as an example.
The System 4 will control the System 8/10 P
RS-232 port, by way of a System 4 Slave Adapter described in the System 4
User's Manual.
INPUT 1
Nine audio connectors are shipped with each System 8 P
each System 10 P . If more are needed, use Phoenix® audio connectors,
LUS
Extron part number 10-163-01.
See previous pages to set up the System 8/10 P
After making all the cable connections, go to page 4-7 of the System 4 User's
Manual to configure the master/slave as a system.
Tel. 07131 911201
Fax 07131 911203
Looping with System 4 xi
Switcher through the secondary
LUS
INPUT 2 INPUT 3 INPUT 4
DIP switches.
LUS
ce-info@camboard.de
Extron • System 8/10 P
OUTPUT
see notes and page 2-6
concerning audio connections
and eleven with
LUS
• User's Manual
LUS