Removing The System 8/10 Plus Cover; Changing Sw1 Switch Settings - Extron electronics System 8 Plus User Manual

im Vertrieb von
Reference
Removing the System 8/10 P
_____ Do NOT touch any switches or electronic components, other than those
(French) Enlever le couvercle du Système 8/10 P
(German) Entfernung der System 8/10 P

Changing SW1 Switch Settings

_____ The SW1 DIP switches, as illustrated below, should ONLY be changed when
Note: Only switches 3 and 4 may be reset!
1 2 3 4 5
ON
OFF
OPEN
59 ,125MEJ?DAI
www.camboard.de
B-3
CAMBOARD Electronics
Cover
LUS
There is rarely a need for the user to remove the System 8/10 P
Three possible reasons would be:
• To change the Main Controller Board SW1 switch settings (switches 3 & 4
only)
• To change the Host baud rate from the factory setting of 9600 baud
• To upgrade the Main Controller Board Software chip
1. Unplug the AC power cord.
2. If rack-mounted, remove the System 8/10 P
3. Remove all input and output cables.
4. Place the System 8/10 P
screws shown in the picture.
5. Go to the procedure for which you have opened the cover (see following pages).
specified. This could seriously affect the operation of the system.
6. When finished working inside the System 8/10 P
reverse to replace the cover.
- page B-9
LUS
Abdeckung - seite B-11
LUS
resetting switches 3 and 4! Switches 1, 2, and 5 must NEVER be reset! Failure
to heed this warning could seriously affect the operation of the switcher.
Locate SW1 on the Main Controller board (see diagram on next page).
Switch 3: When set "ON" - if the connected projector is in 'Display Mute' mode,
the front panel's Input Select button will not be illuminated.
When set "OFF" - if the connected projector is in 'Display Mute' mode,
the front panel's Input Select button will be illuminated.
Tel. 07131 911201
Fax 07131 911203
from the mounting rack.
LUS
on a clean work space and remove the six (6)
LUS
LUS
ce-info@camboard.de
Extron • System 8/10 P
Removing the Cover
cover.
LUS
, use this procedure in
• User's Manual
LUS