Lus In A Rack - Extron electronics System 8 Plus User Manual

im Vertrieb von
Rear Panel Connections
Cabling a System 8/10 P
_______ The holes in the top and bottom of the System 8/10 P
_______ Maximum ambient operating temperature must not exceed 104° F (40° C).
_______ The mounting rack and all equipment mounted in it must be grounded according
_____ Keep power and signal cables separate (power cables on the right and signal
(French)
Câbler un Système 8/10 P
(German)
Verkabelung vom System 8/10 P
Gestells - seite B-12
www.camboard.de
2-13
CAMBOARD Electronics
in a Rack
LUS
When routing cables from one unit to another in a rack,
do NOT allow the cables to pull down on the
equipment. Use "Tie Wraps", "Rip-Ties" or other
devices to secure the cables at some location in the
rack that is above the rear panel connectors. Loosely
hanging cables may be stepped on, resulting in
damage to cables and equipment, as well as injury to
personnel.
The illustration shows the rear view of a system rack.
The example has the cables tied to the rack above the
connections to the equipment. This allows a clear view
of the back panels and prevents the cable weight from
pulling down on the equipment.
cooling. Do NOT cover these holes. This could cause overheating of vital
components.
to national and local electrical codes.
cables on the left.)
sur un rack - page B-10
LUS
innerhalb eines
LUS
Tel. 07131 911201
Fax 07131 911203
enclosure are for
LUS
ce-info@camboard.de
Extron • System 8/10 P
LUS
Rack Mounting
• User's Manual