S-Video Input Connections; Input Selection Switches - Extron electronics System 8 Plus User Manual

im Vertrieb von
Rear Panel Connections

S-Video Input Connections

Input Selection Switches

_______ If audio input uses the Phoenix connector, the output must also use the Phoenix
www.camboard.de
2-9
CAMBOARD Electronics
S-Video or S-VHS is typically an output from the AV source on a 4-pin miniature
DIN type connector which must be converted to 2 BNC type connectors – one for
chrominance (C) and the other for luminance (Y) - [Extron adapter cable 26-353-
01]. S-Video input to the System 8/10 P
(C) to the H/HV/C input connector and the luminance (Y) to the G/Video/Y input
connector. Audio inputs from the AV source are made to either the R & L inputs
of the System 8/10 P or to the R/R-Audio and B/L-Audio BNC connectors.
LUS
Each input must be configured. This is done by setting the DIP switches located
above the output connectors. There are two banks of DIP switches, each having
8 (or 10) switches. Each input channel has two switches assigned to it, one in
each bank. For example, input #3 uses the third switch at each bank. For the S-
Video input shown below (S-Video signal connected to channel 3 input), the #3
DIP switch of S-Video/S-VHS bank should be in the up (Video) position and the
#3 DIP switch of the NTSC/PAL should be in the down (RGBS) position.
Place the S-Video/S-VHS switch for the input channel being configured in the
Video (up) position. The NTSC/PAL switch for this channel (input 3, in this
example) must be in the down position.
When the System 8/10 P
LUS
marked "S-Video" will light. See arrow in illustration below.
connector. If the input uses BNC connectors, the output must also use BNC
connectors.
Tel. 07131 911201
Fax 07131 911203
is made by connecting the chroma
LUS
selects this input, the LED next to the output
ce-info@camboard.de
Extron • System 8/10 P
S-Video Input
• User's Manual
LUS