Special Features; Input Selection Switches - Extron electronics System 8 Plus User Manual

im Vertrieb von

Special Features

Special Features

Input Selection Switches

www.camboard.de
Extron • System 8/10 P
LUS
CAMBOARD Electronics
The System 8/10 P
LUS
Detect. Auto Sync Detect determines what type of RGB sync is being input.
Sometimes this feature must be disabled when connecting to certain projectors.
For example, if a Barco projector is powered up with no input yet present at the
switcher, the projector will not detect any sync and will default to sync on Green.
Later, if an RGB source with separate sync is connected to the System 8/10
P , the Barco projector, which is still expecting sync on Green, may
LUS
experience problems dealing with this conflicting situation. However, by setting
both Input Selection DIP switches up (disabled), the switcher will disable Auto
Sync Detect which will communicate to the projector that the RGB input has
separate sync. Similarly, if Auto Sync Detect is enabled (both DIP switches
down) for an RGB input, the switcher communicates to the projector that the
RGB input has sync on Green.
Each input must be configured. This is done by setting the DIP switches located
above the output connectors. There are two banks of DIP switches, each having
8 (or 10) switches. Each input channel has two switches assigned to it, one in
each bank. For example, input #2 uses the second switch at each bank. By
setting input #2 up in both banks, the Auto Sync Detect feature will be disabled
and the RGB sync will be defined as separate sync (as described above).
Tel. 07131 911201
• User's Manual
Fax 07131 911203
has some special features, one of which is Auto Sync
ce-info@camboard.de
Rear Panel Connections
2-12