Cleaning - Presto Conti Compact Series Operating And Maintenance Instructions Manual

PRESTO
GmbH & Co. KG
Bad Laer
The operator of the unit has to notify his
superior as soon as possible about any
occurring trouble or irregularity. The same
applies for mechanical and electrical
equipment.
See to it, that the operating instructions
belonging to the channel-type baling press,
the maintenance and special tools and
devices, the oil cans and grease guns
required for lubrication is always kept in the
provided receptacles.
When dealing with oils, greases and other
substances the specific safety regulations
and legal provisions which are valid for the
product have to be observed!
Observe adjustment and maintenance works
described in the operating instructions
including information for the replacement of
parts/partial equipment!
These works may be carried out by qualified
persons with sufficient knowledge and
corresponding tools.
Danger of injury! Before
carrying out any cleaning
and maintenance work,
always check the area for
foreign matter such as
sharp-edged material, one-
way injection needles etc.
contaminated materials
have been compacted.
Contact the operators before if required.
Non-compliance may cause severe health
problems.
Also check whether
7.2.
Properly clean the unit weekly or in case of
excessive pollution.
Put main switch (1) in "0" position, pull out
yellow safety bow and secure with a padlock.
Do not direct water nozzle directly to
electrical components, bearing- and
lubrication points.
Inspect and clean the area (1) behind the
press body.
Inspect and clean the hollow spaces on both
sides in which the lateral beams of the press
body are immersing.
04/2012 7 - 2

Cleaning

Cut off electrical current
prior to starting the
cleaning.