Operating Elements And; Operating Elements - Presto Conti Compact Series Operating And Maintenance Instructions Manual

PRESTO
GmbH & Co. KG
Bad Laer
6. Operating elements and operation
6.1. General
The channel-type baling press has left our
plant ready for operation. Please check
stationary compression unit for damages by
visual inspection and function test and
inform your forwarding agent immediately
about possible complaints.
Works at/with the unit may
only be carried out by
instructed, reliable staff
and/or by experts.
In general the function and operation of all
types of channel-type baling presses is
similar. There are, however, differences with
regard to the pressing power. This results in
considerable differences in the control and
work sequence.
Prior to the commissioning make sure what
kind of channel-type baling press you use
(see type plate and chapter 4 "Technical
data").
Any accessories, which form part of the
special equipment, are described in the
following point. You will find a more detailed
description with regard to this extra
equipment in chapter 11 "Appendix, special
equipment."
6.2.

Operating elements

This section describes the operating
elements of the channel-type baling press
CC-13, CC-20, CC-30 and CC-40 with fully
automatic tie-off device.
With respect to all types of channel-type
baling presses the essential operating
elements necessary for the operation are
located centrally in the switch box. If
applicable there might be a Button bar in the
rear area of the unit.
Switch box for channel-type baling press
Type CC-13V, CC-20V, CC-30V and
CC-40V
>> fully automatic tie-off device <<
1. Main switch
2. "Start" Button
3. Illuminated switch "Operation"
4. "Emergency-off" switch
5. Button "Press forward"
6. Button "Press backward"
7. Button "Needle up"
8. Button "Needle down"
9. Selector switch "Twisting"
10. Selector switch "Cutting"
04/2012 6 - 1