Compacting Process; Operation Mode "Manual - Presto Conti Compact Series Operating And Maintenance Instructions Manual

PRESTO
GmbH & Co. KG
Bad Laer
6.4.

Compacting process

Attention! Danger of
Never climb into charging
opening while the channel-
type baling press is in

Operation mode "Manual"

This operation mode is normally intended for
maintenance and repair works.
The unit is ready to use, i.e. the safety switch
is unlocked, the covers are closed.
Ensure that no persons are endangered.
• Switch on main switch, press button
operation, light "operation" is lighting.
• Put operation mode selector switch into
"Manual" position
• Press "Start" Button, the hydraulic pump
starts up.
• Move selector switch "Press
forward/back" into desired direction and
keep as long as the press is to be moved.
crushing!
operation.
04/2012
When running forward care has to be taken
that in the front final position there is not
cut-off by the limit switch. Observe the
pressure gauge. If the press is drawn back
manually the rear limit switch cuts off the
valve automatically when having reached the
limit switch.
Operation mode "Auto"
See to it that no persons are
endangered by the operation
of the unit!
For the fully automatic tie-off device you
should use coiled binding wire. In order to
safeguard a proper function you should use
binding wire which you can acquire through
our service department.
Properties:
• Binding wire for CC-13V and CC-20V on a
20 kg-coil, patent coiling, 2.8 mm
diameter, close annealed and oiled.
• Binding wire for CC-30V and CC-40 on 40
kg-coil patent coiling, 3.1 mm diameter,
close annealed and unoiled.
6 - 4