Troubleshooting Router Boot-Up And Operation - Juniper LN1000 User Manual

CHAPTER 8
Troubleshooting Router Boot-Up and
Operation
SPOST and POST Diagnostic Tests
Related
Documentation
SPOST and POST Diagnostic Tests on page 35
Accelerating the LN Series Router Boot-Up Process on page 36
Accessing the Extended Diagnostic Tests on page 41
LN1000 Mobile Secure Router Status LED on page 42
LN1000 Rear Transition Module Front Panel Status LEDs on page 43
Startup power-on self test (SPOST) and power-on self test (POST) diagnostic tests run
automatically on the LN1000 Mobile Secure Router as part of the boot-up process at
every power on, reset, or warm reboot.
SPOST diagnostics consist of a limited suite of quick diagnostics that ensure that
system components required for Boot Loader and diagnostics relocation and execution
from RAM are working without error.
POST diagnostics consist of a suite of quick diagnostics that ensure that components
of the system are working without error before trying to load and execute Junos OS.
PASS/FAIL test results for the SPOST and POST diagnostics are reported by means of
the front panel LED, console port, and IPMI.
In the event that SPOST, POST, or the bootstrap sequence reports a failure and the front
panel LED lights red, extended diagnostic tests are available. For information about
running extended diagnostic tests, contact Juniper Networks at
http://www.juniper.net/in/en/contact-us/
LN1000 Mobile Secure Router Status LED on page 42
Powering On the LN1000 Mobile Secure Router on page 25
LN1000 Router Power Requirements on page 13
.
35