Powering On The Ln1000 Mobile Secure Router - Juniper LN1000 User Manual

Related
Documentation

Powering On the LN1000 Mobile Secure Router

To remove the router from the chassis:
Using a 3/32 Allen wrench, loosen the two wedge locks on the front panel of the
1.
LN1000 router.
Lift the injector/ejector latch on the right side of the router front panel to disengage
2.
the connector on the router from the backplane connector.
Slide the router out of the guide rails.
3.
LN1000 Mobile Secure Router Description on page 3
Before You Install the LN1000 Router on page 23
Powering On the LN1000 Mobile Secure Router on page 25
The LN1000 router derives its power from the chassis in which it is installed; it
automatically powers on when inserted into the connector in the VITA 46.0-compliant
chassis.
Monitor router startup on the console and the LED on the front panel of the LN1000
router to verify that the router is booting properly.
As a standard part of the boot process, the router runs startup power-on self test (SPOST)
and then power-on self test (POST) diagnostics. A successful startup looks similar to
the following example:
CPU Memory (Data32: 00000000-0007ffff) test completed, 1 pass, 0 errors
CPU Memory (Data32: 0f000000-0fffffff) test completed, 1 pass, 0 errors
CPU Memory (Addr32: 00000000-0007ffff) test completed, 1 pass, 0 errors
CPU Memory (Addr32: 0f000000-0fffffff) test completed, 1 pass, 0 errors
Boot Flash: 16 MB in 131 Sectors (portwidth: 16bit
OCTEON CN56XX pass 2.0, Core clock: 600 MHz, DDR clock: 266 MHz
Initializing USB
Device 1:
Product DOTG Root Hub
Device 2:
Manufacturer
Product USB Flash Memory
SerialNumber 00147808E485C92043770566
Initializing IDE
Initializing FPGA
Programming /cf/usr/share/pfe/firmware/563-029572.bit: 2067590 bytes
Programmed successfully (time: 883475051 ticks)
Checking for init_data
No init_data
PCIe: Waiting for port 0 link
PCIe: Port 0 link active, 1 lanes
Probing PCIe port 0
Chapter 6: Installing the LN1000 Mobile Secure Router
chipwidth: 16bit)
25