Table 6: Ln1000 Router Led Status; Ln1000 Mobile Secure Router Status Led - Juniper LN1000 User Manual

LN1000 Mobile Secure Router
Related
Documentation

LN1000 Mobile Secure Router Status LED

Table 6: LN1000 Router LED Status

Color
Off; No color
Steady Red
Steady Green
Blinking Green
Related
Documentation
42
You access submenus by entering the abbreviated menu name. For example, to enter
the Flags menu, from the Diagnostic CLI menu interface enter the
To return to a higher level menu, press
To exit the Diagnostic Menu Interface, press
from any menu level.
All diagnostic commands available from the Diagnostic CLI menu interface are available
from the bootstrap prompt for scripting. Diagnostic test execution is the same either
when run from the CLI Diagnostic menu or using test scripting, and results are output to
the console port and diagnostic log.
Using command scripting, you can create a sequence of diagnostic commands and flags.
Command sequences are terminated by a carriage return.
For example, to perform a fast memory test on 1000 bytes starting at address 0, at the
bootstrap prompt enter the
is equivalent to entering the Diagnostic CLI menu interface, navigating to the Board Menu,
and then to the Memory menu and executing the fast memory test.
SPOST and POST Diagnostic Tests on page 35
Powering On the LN1000 Mobile Secure Router on page 25
LN1000 Router Power Requirements on page 13
Upon initial power-on, the components of the router run boot code, go through a series
of self-diagnostic tests, and synchronize with each other. When the tests are complete,
use the LED on the router front panel to determine the status of the router.
Meaning
Power is off.
Error condition.
Ready for operation. The router is powered on and has successfully booted and run
SPOST and POST diagnostics.
Powering on and then running SPOST and POST diagnostics, or running individual
diagnostics, or performing an upgrade.
Accessing the Extended Diagnostic Tests on page 41
SPOST and POST Diagnostic Tests on page 35
LN1000 Router Power Requirements on page 13
Ctrl-U .
to return to the Bootstrap prompt
Ctrl-X
diags board memory fast 0 1000
command.
flags
command. This command