Temperature Alarm - Siemens SIMOTION Series Commissioning And Hardware Installation Manual

Alarm, error and system messages

12.2 Temperature alarm

If the dialog box is closed without deactivating the Flashing function, the previous state of the
LED becomes active again.
Table 12-3 LED combinations
LED SF
DCP flashing x
x Not applicable
1 ON
2 Flashes with a frequency of 2 Hz.
Note
You can carry out a detailed diagnosis using a PG/PC and the Engineering System.
FAULT
A fault has occurred to which the user program cannot respond.
The following actions may be required to rectify the fault:
● Power OFF/ON
● Recommissioning
Table 12-4 LED combinations
LED SF
FAULT 5
(red)
5 Flashes with a frequency of 5 Hz.
12.2 Temperature alarm
For SIMOTION P320‑4, two different temperatures are monitored in the device as regard to
whether they reach their respective threshold value.
System variables
_cpudata.temperature
_cpudata.moduletemperature
Error response
An I/O alarm is activated.
196
RUN STOPU
2 x
(green/yel‐
low)
RUN STOPU
5 5
(red) (red)
STOP SF PN
x x
STOP SF PN
5 5
(red) (red)
Commissioning and Hardware Installation Manual, 11/2016
SY/MT BUSF1
x x
SY/MT BUSF1
5 5
(red) (red)
SIMOTION P320-4 E / P320-4 S
BUSF2
x
BUSF2
5
(red)