Program Selection; Direct Model Selection - DURKOPP ADLER 550-12-24 Instructions For Operating Manual

3.3 Program Selection

3.3.1 Direct Model Selection

6
If the model number is known, it can be entered directly.
Order of operations
–
Press the "P" key.
The following display appears :
–
Enter the model number.
The numeric entry occurs with the 0 to 9 keys. After the entry of
the third number, the entry is automatically concluded. The model
number entry is concluded after less than three digits by pressing
the "E" key. If the model exists in the memory, the following
appears in the display :
–
After a program is activated, the step 01 is set after 2 seconds.
The program is immediately ready for operation.
The automatic mode is activated.
–
If the model is not in the memory, the left display blinks. By holding
down the "Y" key and tapping the "P", the entry of a new program
can now begin (see Chapter 4.3). The program selection is aborted
by pressing the "E" key.