Additional Thread Tension; Needle Position During Drive Stop; Foot Position During Drive Stop - DURKOPP ADLER 550-12-24 Instructions For Operating Manual

6.1.6 Additional Thread Tension

6.1.7 Needle Position during Drive Stop

6.1.8 Foot Position during Drive Stop

20
With this parameter the crimping value as of which the additional
thread tension is automatically turned on can be set.
Order of operations
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned on.
–
Advance to the desired parameter through repeated pressing of
the "Y" key.
–
Press the key of the crimping value as of which the additional
thread tension is to be turned on.
Key 1 : As of crimping value 1
to
Key 15 : As of crimping value 15
With this parameter the position in which the needle stops when the
drive stops is set.
Order of operations
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned on.
–
Advance to the desired parameter through repeated pressing of
the "Y" key.
–
Press the appropriate key for the desired needle position.
Key 0 : Unpositioned
Key 1 : Position 1 (low)
Key 2 : Position 2 (high)
Key 3 : Position neutral point EFKA
After the setting of the parameter the machine must be turned off and
then on again so that the value becomes effective.
With this parameter the position in which the pressure foot stops when
the drive stops is set.
Order of operations
–
Hold down the "Y" key and tap the "F" key.
The parameter menu is turned on.
–
Advance to the desired parameter through repeated pressing of
the "Y" key.
–
Press the appropriate key for the desired pressure foot position:
Key 1 : Position 1 (low)
Key 2 : Position 2 (high)