Switching Of Individual Outputs - DURKOPP ADLER 550-12-24 Instructions For Operating Manual

5.4 Switching of Individual Outputs

In this test program all outputs can be switched individually. The
change of a switch is shown in the display.
No. Description
1 Lifting the pressure foot
2 Thread tension solenoid valve
3 Vertical cutter solenoid valve
4 Lift adjustment solenoid valve
5 Tape brake solenoid valve
6 Needle cooling
9 Tape advance / blower solenoid valve
10 Tape clamp solenoid valve
11 Tape cutter solenoid valve
13 LED for the lift adjustment
14 LED for the vertical cutter
15 LED for stitch condensation
20 Multiposition cylinder II position 1
21 Multiposition cylinder II position 2
22 Multiposition cylinder II position 4
23 Multiposition cylinder II position 8
24 Multiposition cylinder II position 16
25 Multiposition cylinder I position 16
26 Multiposition cylinder I position 8
27 Multiposition cylinder I position 4
28 Multiposition cylinder I position 2
29 Multiposition cylinder I position 1
Order of operations
–
Turn on the test mode (see Chapter 5).
–
Advance to the desired program by pressing the "Y" key.
–
The outputs can be run through consecutively with the "P" key.
–
Individual outputs can be selected directly with the 0 to 9 keys.
–
Press the "E" key.
The switching status of the selected output changes.
The display shows e.g.:
3
15