Tape Advance - DURKOPP ADLER 550-12-24 Instructions For Operating Manual

3. Setting the Tape Feed and Cutter (model 550-12-26 only)
3.1

Tape Advance

44
The fabric-advance setting should be such that the fabric channel can
be inserted into the needle-plate slot without touching the needle plate.
Caution Risk of Injury!
Before adjusting turn the main switch off.
–
Remove the tension spring 6.
Horizontal adjustment
–
Undo locking screw 5.
–
Alter the position of the fabric advance by rotating block 2.
Bolt 1 must make pressure-free contact with the base plate.
–
Tighten locking screw 5.
Vertical adjustment
–
Undo screws 3 and 4.
–
Alter the position of the fabric clamp.
The alignment of the fabric clamp must be such that it runs
centrally in the needle-plate fabric channel.
–
Tighten screws 3 and 4.
Vertical adjustment
–
Fit the tension spring 6.
1
2
3
4
5
6