2.12.2 Height of the Feed Dogs
5
4
3
The feed dogs in their highest position should protrude 1.2 mm out of
the needle plate. (slot B)
Caution Risk of Injury!
Before adjusting turn the main switch off.
–
Arrest the pressure feet in the raised position.
–
Arrest the handwheel in slot B.
–
With a feeler gauge check the height.
–
Loosen screws 3, 4 and 5 on the stroke levers and alter the height
of the feed dog carriers.
Attention!
When tightening screws 3 and 5, take care that the feed dog support
is set close at the side.
2
23