Original Exit Solenoid (Solr3) - Toshiba e-STUDIO555 Service Manual

15.5.33 Original exit solenoid (SOLR3)

(1) Take off the RADF board bracket.
P.15-16 "15.5.3 RADF rear cover"
(2) Disconnect 1 connector.
(3) Remove 2 screws and take off the original
exit solenoid with the bracket.
(4) Remove 2 screws and take off the bracket
from the original exit solenoid.
Note:
Before taking off the solenoid, read the scale.
When reinstalling, align it with the
corresponding position on the scale.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Fig. 15-105
Fig. 15-106
Fig. 15-107
REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
15 - 45
e-STUDIO555/655/755/855
15