Glass Frame Assembly; Glass Frame Assembly Identification - Heat & Glo Foundation Series Installation And Operating Manual

A. GLASS FRAME ASSEMBLY IDENTIFICATION
Figure 6A
CAUTION: TO PREVENT GLASS FRAME ASSEMBLY FROM FALLING FROM FIREPLACE AND BECOMING DAMAGED,
FOLLOW THE INSTRUCTIONS EXACTLY WHEN REMOVING AND INSTALLING GLASS FRAME ASSEMBLY.
STOP: DO NOT OPERATE THIS FIREPLACE WITH THE GLASS REMOVED, CRACKED OR BROKEN. REPLACEMENT OF
GLASS ASSEMBLY SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.

WARNING! RISK OF INJURY! DO NOT remove glass until it is cooled to room temperature. Glass breakage could occur.
NOTE: GLASS REMOVAL AND INSTALLATION MUST BE PERFORMED WITH TWO PEOPLE.
NOTE: Glass must be removed using quality suction cups.
DO NOT attempt to remove the glass without using proper suction cups.
NOTE: IN CASE OF CHIPPED OR BROKEN GLASS
Have your dealer assist you with contacting Hearth & Home Technologies to get the proper glass replacement.
14
Heat & Glo • FDN-4-ST, FDN-5-ST, FDN-6-ST, FDN-7-ST Installation Manual • 16400-9801 Rev. H • 11/19

6 - GLASS FRAME ASSEMBLY

UPPER GROOVE
QUALITY
SUCTION CUP
LOWER FILLER STRIP
SITS OVER GLASS CLIPS
LOWER GROOVE
GLASS
GLASS CLIP
Figure 6B.1