Table of Contents
Advertisement
11
Appliance Setup
A. Remove Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front.
2. The glass assembly has two upper spring latches
and two lower spring latches. See Figure 11.1. Lo-
cate the two spring latches that are on the upper left
and right of the fireplace.
3. Pull upper spring latch on one side forward to release
glass assembly while supporting glass assembly with
opposite hand. Repeat for the other upper spring
latch always taking care to support the glass assem-
bly with one hand.
4. Grasp glass on the upper right and left sides and
remove glass assembly by lifting "up" and "out".
Note: Observe the presence of a space or gap between
the glass latch and the front of the appliance where the
bottom of the glass assembly is positioned. This gap is
designed for positive placement when replacing the glass
assembly. See Section 11.I.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the firebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative front of the appliance,
depending on the fireplace model. Splatter guards
must be removed before appliance is fired.
• The left and right side non-combustible boards are
packaged within the splatter guard. Remove them
by carefully disengaging the tabs from the slots on
the lower portion of the splatter guard. Install as
instructed in Section 6.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
60
Majestic • JADE32IN, JADE42IN, JADE42IL Installation Manual • 2491-986 Rev. L • 4/19
UPPER SPRING LATCH
LOWER SPRING LATCH
Figure 11.1 Fixed Glass Assembly
D. Install the Glass Refractory (Optional)
An optional glass refractory kit is available for use with the
JADE42IN/JADE42IL and JADE32IN models. Install the
glass refractory per instructions included with the kit.
GAP
Advertisement
Table of Contents
