Table of Contents
Advertisement
11 11
Appliance Setup
A. Remove Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass assembly from the
appliance See Figure 11.1.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 11.1 Fixed Glass Assembly
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the firebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative front of the appliance,
depending on the fireplace model. Splatter guards
must be removed before appliance is fired.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
58
Heat & Glo • 6000CL-IFT, 8000CL-IFT Installation Manual • 2504-980 Rev. Q • 11/21
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Burner Top Installation
1. Bend the two tabs upward as shown in Figure 11.2
2. To install the fiber burner, mate the locating holes with
the guide sleeves. Install fiber burner top so that it
makes full contact with the underlying burner assem-
bly.
3. Ensure that the ports in the steel burner are visible
through the holes in the fiber burner top.
FIBER BURNER TOP
BEND TABS UP
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 11.2
LOCATING HOLES
AIR SCOOP
PILOT COVER
BURNER SHIELD
Advertisement
Table of Contents
