Install Glass Frame Assembly; Remove Glass Frame Assembly - Heat & Glo Foundation Series Installation And Operating Manual

Refer to Glass Frame Assembly Identification Figures 6A & 6B.1 when installing and removing the glass frame assembly.
B. INSTALL GLASS FRAME ASSEMBLY
U-Shaped
Edge
Protector
Figure 6B.2
Figure 6B.3
Figure 6B.4
C. REMOVE GLASS FRAME ASSEMBLY

WARNING! RISK OF INJURY! DO NOT remove glass until it is cooled to room temperature. Glass breakage could occur.
1. Apply the suction cups to the outer glass panel following the instructions included with the suction cups.
2. Gently lift the glass until the bottom edge is clear of the groove it sits in.
3. Bring the bottom edge of the glass towards you while lowering it to disengage it from the top groove.
4. Sit the glass on a padded surface to protect it. IMPORTANT: Protect the glass's edges.
5. Remove the lower trim panel that sits between the layer of glass.
6. Remove the inner trim vertical panels.
7. Using the suction cups, remove the inner panel in the same manner.
Heat & Glo • FDN-4-ST, FDN-5-ST, FDN-6-ST, FDN-7-ST Installation Manual • 16400-9801 Rev. H • 11/19
6 - GLASS FRAME ASSEMBLY
Top/Bottom Glass Pane
ASSEMBLY
IMPORTANT: PLASTIC GLASS EDGE PROTECTORS
The fireplace is shipped with plastic edge protectors on the
outer panes of glass only.
If the edge protectors on the outer panes of glass are not
installed, the glass may rattle during operation. See Figure
6B.2.
Inner Glass
1. Unwrap the panes of glass carefully making sure to
protect the edges.
2. Apply the suction cups to the inner glass assembly,
following instructions included with the suction cups.
3. Lift the glass into place. The top edge slips into the
top groove, lift into the groove until the bottom is clear
of the bottom trim. Slide the glass down into the
inner bottom groove. See Figure 6A.
4. Push inner trim vertical panels into place on each
side. See Figure 6B.3.
5. Place the lower trim panel between the lower glass
clips. Slide back against the vertical trim piece. See
Figure 6B.4.
6. Repeat process for all inner glass panels on
appliance.
Outer Glass
7. Apply the suction cups to the outer unframed glass
(which has the U-shaped edge protector) and lift it
into place in the same manner as the inner glass.
8. Repeat process for installing all outer glass panels on
appliance.
15