Table of Contents
Advertisement
A. INNER GLASS FRAME ASSEMBLY IDENTIFICATION & INSTALLATION
Figure 6A
CAUTION: TO PREVENT GLASS FRAME ASSEMBLY FROM FALLING FROM FIREPLACE AND BECOMING DAMAGED, FOLLOW
THE INSTRUCTIONS EXACTLY WHEN REMOVING AND INSTALLING GLASS FRAME ASSEMBLY.
STOP: DO NOT OPERATE THIS FIREPLACE WITH THE GLASS REMOVED, CRACKED OR BROKEN. REPLACEMENT OF GLASS
ASSEMBLY SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.
WARNING: RISK OF INJURY!
DO NOT remove glass until unit is cooled to room temperature. Glass breakage could occur.
NOTE: GLASS REMOVAL AND INSTALLATION MUST BE PERFORMED WITH TWO PEOPLE.
NOTE: Glass must be removed using quality suction cups.
DO NOT attempt to remove the glass without using proper suction cups.
NOTE: IN CASE OF CHIPPED OR BROKEN GLASS
Due to the size and sensitivity of shipping the glass separately, it is best to have the replacement glass cut locally if needed.
Have your local dealer assist you with contacting Stellar Hearth Products directly to get the proper glass specifications.
Page 24
6 - GLASS FRAME ASSEMBLY
Inner Glass Installation
1.
2.
3.
Quality
Suction Cup
4.
Unwrap the panes of glass carefully making sure to protect the
edges.
Apply the suction cups to the inner glass assembly, following
instructions included with the suction cups.
Lift the glass into place. The top edge slips into the top groove,
lift into the groove until the bottom is clear of the bottom trim.
Slide the glass down into the inner bottom grove. See Figure 6A
Follow these instruction for installing the inner glass on both sides
of the IDOD See Though.
INS_CUST
Advertisement
Chapters
Table of Contents
