Lighting & Shutdown; Lighting The Fireplace - Heat & Glo Foundation Series Installation And Operating Manual

STOP: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING
PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
D
UE TO HIGH SURFACE TEMPERATURES, KEEP CHILDREN, CLOTHING AND FURNITURE AWAY.
This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation
air. It is important to make sure the termination cap remains unobstructed at all times from snow, ice, leaves or other debris.
•
This fireplace is equipped with an ignition device
which automatically lights the pilot and main burner.
The pilot and burner light automatically with the wall
switch. DO NOT try to light the pilot by hand. Before
lighting this fireplace, follow these instructions exactly.
•
BEFORE LIGHTING, smell all around the appliance
for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
•
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system which has been under water.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE
NOTE: A PAINT SMELL WILL OCCUR DURING THE FIRST FEW HOURS OF BURNING.
NOTE: THIS FIREPLACE MAY PRODUCE NOISES OF VARYING DEGREE AS IT HEATS AND COOLS DUE TO METAL
EXPANSION AND CONTRACTION. THIS IS NORMAL AND DOES NOT AFFECT THE PERFORMANCE OR LONGEVITY OF THE
FIREPLACE.
A. LIGHTING THE FIREPLACE
To light the fireplace:
Activate the wall switch.
The fireplace has a pre and post timer, set at the factory for 30 seconds. The powervent and flame will not turn on for 30-60 seconds after switch is
activated and the powervent will run for 30 seconds after it has been shut off.
38
Heat & Glo • FDN-4-ST, FDN-5-ST, FDN-6-ST, FDN-7-ST Installation Manual • 16400-9801 Rev. H • 11/19
11 - LIGHTING & SHUTDOWN
FOR YOUR SAFETY - READ BEFORE LIGHTING
VICINITY OF THIS
WHAT TO DO IF YOU SMELL GAS:
•
Do not touch any electrical switches
•
Do not try to light any appliance
•
Do not use the phone in your building
•
Immediately call your gas supplier from a neighbor's
phone
•
Follow the gas supplier's instructions
•
If you cannot reach your gas supplier, call the fire
department
OR ANY OTHER APPLIANCE