Connecting The Power Cord; Connecting An Ac Power Cord To The Switch - H3C S5800 Series Installation Manual

Connecting the power cord

Table 33 Power cord connection procedures for the S5800 switches
Power module
Fixed power module
AC input
–54 VDC input (RPS powered)
12 VDC input (RPS powered)
Hot swappable power modules
PSR150-A
PSR150-A1
PSR150-D
PSR150-D1
PSR300-12A
PSR300-12A1
PSR300-12A2
PSR300-12D1
PSR300-12D2
PSR750-A
PSR750-D
LSVM1AC650
LSVM1AC300
LSVM1DC650
LSVM1DC300

Connecting an AC power cord to the switch

To connect an AC power cord to a switch that uses fixed power modules:
1. Install the bail latch, fix the bail latch into the holes located at the two sides of the AC-input power
receptacle, and pull the bail latch upwards (see
2. Connect one end of the AC power cord to the AC-input power receptacle on the switch (see callout
1 in Figure 57
3. Pull the bail latch down to secure the plug to the power receptacle (see callout 2 in
or Figure
Connection procedure reference
Connecting an AC power cord to the switch
Connecting the switch to a –54 VDC output RPS
Connecting the switch to a 12 VDC output RPS
Connecting the PSR150-A/PSR150-A1
–48 VDC input:
Connecting the PSR150-D/PSR150-D1 to a –48 VDC power source
–54 VDC input (RPS powered):
Connecting the PSR150-D/PSR150-D1 to a –54 VDC output RPS
Connecting the PSR300-12A/PSR300-12A1/PSR300-12A2
–48 VDC input:
Connecting the PSR300-12D1/PSR300-12D2 to a –48 VDC power
source
–54 VDC input (RPS powered):
Connecting the PSR300-12D1/PSR300-12D2 to a –54 VDC output RPS
Connecting the PSR750-A
–54 VDC input (RPS powered):
Connecting the PSR750-D to a –54 VDC output RPS
Connecting the LSVM1AC650/LSVM1AC300
–48 VDC input:
Connecting the LSVM1DC650/LSVM1DC300
or Figure 59).
59).
Figure 56 or
56
Figure 58).
Figure 57