Management Ethernet Port Leds; Oap Card Status Led; Poe Module Status Led - H3C S5800 Series Installation Manual

Table 19 SFP+ port LED description
Port mode LED
(Mode) status
Steady green
(rate mode)
Steady yellow
(duplex mode)

Management Ethernet port LEDs

The S5800-32F and S5800-54S switches have two management Ethernet port LEDs (LINK and ACT).
Table 20 Management Ethernet port LEDs description
LED mark
LINK
ACT

OAP card status LED

The SLOT3 LED on the front panel of the S5800-60C-PWR switch shows the status of the card in the OAP
card slot.
Table 21 OAP card status LED description
LED mark
SLOT3

PoE module status LED

The S5800-60C-PWR switch has a PoE module status LED (SLOT4) on its front panel.
SFP+ port LED status
Steady green
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
Flashing yellow (3 Hz)
Off
Status Description
Off The management Ethernet port is not connected.
Steady green The management Ethernet port is operating at 10/100/1000 Mbps.
Off The management Ethernet port is not receiving or sending data.
Flashing yellow The management Ethernet port is sending or receiving data.
Status
Green
Flashing yellow (1 Hz)
Off
Description
The port is operating at 10 Gbps. The port LED fast flashes
when the port is sending or receiving data.
The port is operating at 1 Gbps. The port LED fast flashes when
the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
The port is operating in full duplex mode. The port LED fast
flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
Description
An OAP card is in the slot and operating correctly.
The slot does not support the OAP card model, or the OAP card
has failed.
The OAP card slot is empty.
24