Installing An Oap Card In An Expansion Interface Card Slot (For The Entire Series But The S5800-54S); Removing The Oap Card In An Expansion Interface Card Slot (For The Entire Series But The S5800-54S) - H3C S5800 Series Installation Manual

3. Pull the ejector levers outward (see callout 4 in
the guide rails (see callout 3 in
Figure 80 Remove the OAP card
(1) OAP card
(3) Pull out the OAP card
WARNING!
Do not touch the protection cover marked by the yellow warning label
Underneath this protection cover is a heat radiator. After the OAP card runs for a period of time, this area
can get as hot as to burn your skin.
CAUTION:
Do not touch the surface-mounted components directly with your hands.
•
Do not use excessive force while removing the OAP card.
•
If you do not install a new OAP card in the slot, install a filler panel to prevent dust from entering the
•
switch and ensure good ventilation in the switch.
Installing an OAP card in an expansion interface card slot (for
the entire series but the S5800-54S)
Unpack the OAP card and use
card slot.
Follow the procedure described in
interface card slot.
Removing the OAP card in an expansion interface card slot (for
the entire series but the S5800-54S)
Follow the procedure described in
expansion interface card slot.
Figure
Figure 80).
(2) Chassis rear panel
(4) Pull the ejector levers outward
Table 27 to check that the card can be installed in an expansion interface
"Installing an interface
"Removing an interface
70
80), and pull out the OAP card slowly along
card" to install the OAP card in an expansion
card" to remove the OAP card in an
on the OAP card.