Connecting The Switch To A -54 Vdc Output Rps; Connecting The Switch To A 12 Vdc Output Rps - H3C S5800 Series Installation Manual

Connecting the switch to a –54 VDC output RPS
This section applies to the S5800-56C-PWR and S5800-32C-PWR switches.
To connect these switches to the RPS that provides –54 VDC output:
1. Unpack the RPS power cord, identify the plug for connecting to the switch, correctly orient the plug
with the RPS DC-input power receptacle on the switch chassis, and insert the plug into the power
receptacle (see callout 1 in
plug into the power receptacle, re-orient the plug rather than use excessive force to push it in.
2. Tighten the screws on the plug with a flat-blade screwdriver to secure the plug into the power
receptacle (see callout 2 in
3. Connect the other end of the power cord to the RPS.
Figure 60 Connect the S5800-56C-PWR/S5800-32C-PWR switch to a –54 VDC output RPS

Connecting the switch to a 12 VDC output RPS

This section applies to the S5800-56C and S5800-32C switches.
To connect these switches to the RPS that provides 12 VDC output:
1. Loosen the captive screws on the RPS DC-input power receptacle cover and remove the cover, as
shown in
connector.)
2. Unpack the RPS power cord, identify the plug for connecting to the switch, correctly orient the plug
with the RPS DC-input receptacle on the switch chassis, and insert the plug into the receptacle (see
callout 1 in
receptacle, re-orient the plug rather than use excessive force to push it in.
3. Tighten the screws on the plug with a flat-blade screwdriver to secure the plug in the power
receptacle (see callout 2 in
4. Connect the other end of the power cord to the RPS.
Figure
Figure
Figure 61. (Put away the cover and re-install it after you remove the RPS DC-input power
Figure 62). The power receptacle is foolproof. If you cannot insert the plug into the
Figure
60). The power receptacle is foolproof. If you cannot insert the
60).
62).
58