Connecting The Lsvm1Dc650/Lsvm1Dc300; Installing/Removing An Interface Card - H3C S5800 Series Installation Manual

Figure 73 Connect the LSVM1AC650/LSVM1AC300
(1) Cable tie
(2) Tighten the cable tie to secure the power cord to the handle of the power module

Connecting the LSVM1DC650/LSVM1DC300

1. Unpack the DC power cord, identify the plug for connecting to the power module, orient the plug
with the power receptacle on the power module, and insert the plug into the receptacle (see
74). The receptacle is foolproof. If you cannot insert the plug into the receptacle, re-orient the plug
rather than use excessive force to push it in.
2. Use a cable tie to secure the power cord to the handle of the power module, as shown in
73.
3. Connect the other end of the power cord to the DC power source.
Figure 74 Connect the LSVM1DC650/LSVM1DC300

Installing/Removing an interface card

This section applies to the S5800 switches that have expansion interface slots. For the interface cards
available for the switches, see
This section uses the LSW1SP4P0 interface card as an example to describe the procedures of installing
and removing an interface card.
1
"Interface cards."
66
2
Figure
Figure