Installing/Removing A Power Module (For The S5800-60C-Pwr And The S5800-32F) - H3C S5800 Series Installation Manual

Installing/Removing a power module (for the S5800-60C-PWR
and the S5800-32F)
Installing a power module
To install a power module into the S5800-60C-PWR or S5800-32F switch:
1. Wear an ESD-preventive wrist strap, ensure a good skin contact, and make sure that the
ESD-preventive wrist strap is correctly grounded.
2. If the power module slot is covered by a filler panel, remove the filler panel first.
3. Before installing a PSR750-A or PSR750-D power module to the S5800-60C-PWR switch, remove
the filler module, as shown in
4. Unpack the power module and check that the power module model is correct.
5. Correctly orient the power module with the power module slot, grasp the handle of the module with
one hand and support the module bottom with the other, and slide the module slowly along the
guide rails into the slot (see callout 1 in
insert the power module into the slot, re-orient the power module rather than use excessive force to
push it in.
6. Fasten the captive screws on the power module with a Philips screwdriver to secure the power
module in the chassis (see callout 2 in
Figure 53 Remove the filler module before installing a PSR750-A or PSR750-D power module
Figure 54 Install a PSR750-A power module
Figure 53.
Figure 54 or Figure
Figure 54 or
1
2
54
55). The slot is foolproof. If you cannot
Figure 55).