Removing An Interface Card; Installing/Removing An Oap Card; Installing An Oap Card In The Oap Card Slot (Only For The S5800-60C-Pwr) - H3C S5800 Series Installation Manual

Removing an interface card

1. Wear an ESD-preventive wrist strap, ensure a good skin contact and make sure that the
ESD-preventive wrist strap is correctly grounded.
2. Use a Phillips screwdriver to loosen the captive screws at both sides of the interface card until all
spring pressure is released.
3. Hold the ejector levers at both sides of the interface card and push them outward. Pull the interface
card along the guide rails until it completely comes out of the switch chassis.
Figure 77 Remove an interface card
(1) Chassis front panel
(3) Pull the ejector levers outward
CAUTION:
Do not touch the surface-mounted components directly with your hands.
•
Do not use excessive force in the operation.
•
• If no new card is to be installed after you remove an interface card, install the filler panel to prevent dust
and ensure good ventilation in the switch.

Installing/Removing an OAP card

Before you install an OAP card, use
your switch and identify in which slot you can install the OAP card.
Installing an OAP card in the OAP card slot (only for the
S5800-60C-PWR)
1. Wear an ESD-preventive wrist strap, ensure a good skin contact and make sure that the
ESD-preventive wrist strap is correctly grounded.
2. Loosen the captive screws on the filler panel over the OAP card slot with a Phillips screwdriver
(see Figure
Table 2
78) to remove the filler panel. Put away the removed filler panel for future use.
(2) Interface card
(4) Pull out the interface card
or Table 27 to check the compatibility of the OAP card with
68