Port Mode Led; Seven-Segment Led - H3C S5800 Series Installation Manual

Port mode LED

The port mode LED indicates the type of information that the network port LEDs are showing. You can use
the port LED mode switching button to change the type of displayed port information.
Table 14 Port mode LED description
LED mark
Mode

Seven-segment LED

The seven-segment LED, together with the system status LED, shows detailed system operating information
(see Table
seven-segment LED can also show the total PoE output power as a percentage of the maximum PoE output
power that the switch can supply (see
Table 15 Seven-segment LED description (I)
System status
LED (SYS) status
Flashing green
Flashing red
Flashing green
Steady red
Steady red
Steady green
Status
Steady green
Flashing green (1 Hz) (available
only for PoE switches)
Steady yellow
15). On the S5800-60C-PWR, S5800-56C-PWR or S5800-32C-PWR switch, the
Seven-segment LED ((Unit) status
The LED displays numbers one by one.
The LED displays flashing numbers.
A bar rotates clockwise around the LED.
The LED displays a flashing F character.
The LED displays a flashing t character.
The LED displays a capital C character.
The LED displays an S character.
Description
The network port LEDs are showing port rates.
The network port LEDs are showing the status of PoE power
supply on the ports.
The network port LEDs are showing duplex modes.
Table 16).
21
Description
POST is running, and the LED displays the
ongoing test item ID.
POST has failed, and the LED flashes the
ID of the failed test item.
Software is loading.
The switch is experiencing a fan failure.
The switch is in an over-temperature
condition.
The switch is the command switch in a
cluster.
The switch is a member switch in a cluster.