Table of Contents
Advertisement
Customized Settings
With the multi-information display
and the INFO ( / ) and SEL/
▲ ▼
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings for ''DRIVER 1'' or
''DRIVER 2''. If ''DRIVER 1'' or
''DRIVER 2'' is not displayed,
customizing is not possible.
To have the driver's ID detected,
make sure your remote is linked to
the system (see
Memory Position
Link
on page
104
). Then use your
remote to unlock the doors (see
Keyless Access Setup
on page
).
108
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park.
To enter the customizing mode,
press and hold the INFO ( / )
button for more than 3 seconds while
the multi-information display is in its
normal mode.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shift lever out
of Park, the display will change to
the normal screen.
You cannot customize the settings
under these conditions:
When the keyless memory
settings are off (see page
If you disconnect the battery, and
then do not unlock the door.
When the multi-information
display does not show the driver's
ID.
2010 RL
Multi-Information Display
▲ ▼
The first customizing menu is:
CHG SETTING (see page
173
).
DEFAULT ALL (see page
Refer to the following table for a
brief summary of each customizable
setting and its default. For more
information, refer to the page
number references in the table.
87
)
85
)
CONTINUED
81
Advertisement
Chapters
Table of Contents
