Front Seat Heaters - Acura 2010 RL Owner's Manual

Passenger's
seat
HEATERS
RL models
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
Driver's
seat
FRONT SEAT HEATER SWITCHES
The ignition switch must be in the
ON (II) position to use the heaters.
Push the top of the switch, HI, to
rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the bottom of the switch. This will
keep the seat warm.
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat's temperature
drops.
2010 RL
In the LO setting, the heater runs
HI
continuously. It does not cycle with
temperature changes.
Follow these precautions whenever
LOW you use the seat heaters:

Front Seat Heaters

Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.
If the engine is left idling for an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
181