Table of Contents
Advertisement
Keyless Access System
Ignition Switch
When you push the ignition switch,
the remote and the vehicle recognize
each other. After the recognition,
the remote indicator flashes, and a
beeper sounds once. After the beep,
turn the ignition switch.
When the remote is out of the
operating range, the ignition switch
is locked.
If the ignition switch cannot be
turned from the LOCK (0) position
to the ACCESSORY (I) position after
176
the beep, the steering wheel is
locked. To unlock the steering wheel,
turn it right and left while turning
the ignition switch at the same time.
If the remote and the vehicle do not
recognize each other, turn the
ignition switch to the LOCK (0)
position, remove the ignition switch
cover, insert the built-in key, and
turn the switch (see pages
177
).
2010 RL
To turn the ignition switch to the
LOCK (0) position, put the
transmission in Park, press the
switch in, and turn it to the LOCK
(0) position. When the transmission
is not in Park, you cannot turn the
ignition switch to the LOCK (0)
position.
152
and
Before leaving the vehicle, make
sure the ignition switch is in the
LOCK (0) position.
If you open the driver's door with the
ignition switch in the ACCESSORY
(I) position, a beeper will sound.
You will also see a ''RETURN
IGNITION SWITCH TO LOCK (0)
POSITION'' message on the multi-
information display.
Advertisement
Chapters
Table of Contents
