Acura 2010 RL Owner's Manual page 499

Jump Starting
Connecting the jumper cable to the
secondary under-hood f use box causes
the f uses to blow.
496
5. Connect the second jumper cable
to the negative ( ) terminal on −
the booster battery. Connect the
other end to the grounding point
as shown. Do not connect this
jumper cable to any other part of
the engine.
6. If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
2010 RL
7. Start your vehicle. If the starter
motor still operates slowly, check
that the jumper cables have good
metal-to-metal contact.
8. Once your vehicle is running,
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
then from the booster battery.
9. Reinstall the secondary under-
hood fuse box cover over the
positive ( ) terminal of the ＋
battery, then reinstall the battery
cover.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until everything is
disconnected. Otherwise, you may
cause an electrical short.