Table of Contents
Advertisement
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking/side marker
lights, and taillights flash if someone
attempts to break into your vehicle
or remove the radio. This alarm
continues for 2 minutes, then the
system resets. To reset an alarming
system before the 2 minutes have
elapsed, unlock either front door
with the remote or the built-in key.
The security system automatically
sets 15 seconds after you lock the
doors, close the hood, and close the
trunk. For the system to activate,
you must lock the doors from the
outside with the remote, built-in key,
lock tab, or door lock switch. The
security system indicator on the
instrument panel starts blinking
immediately to show you the system
is setting itself.
SECURITY SYSTEM INDICATOR
Once the security system is set,
opening any door or the hood
without using the built-in key or the
remote will cause it to sound. It also
sounds if the radio is removed from
the dashboard or the audio system
wiring is cut.
2010 RL
Security System
With the system set, you can still
open the trunk with the remote
without triggering the alarm. The
alarm will sound if the trunk lock is
forced, or the trunk is opened with
the trunk release button on the
driver's door or the emergency trunk
opener.
The security system will not set if
the hood, trunk, or any door is not
fully closed. If the system will not set,
check the Door and Trunk Open
monitor on the instrument panel (see
page
13
) to see if the doors and
trunk are fully closed. Since it is not
part of the monitor display, manually
check the hood.
Do not attempt to alter this system
or add other devices to it.
315
Advertisement
Chapters
Table of Contents
