Acura 2010 RL Owner's Manual page 70

Pull to the side of the road when it is
safe, shift to Park, and let the engine
idle until the indicator goes out.
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
Low Tire Pressure/
TPMS Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
This indicator has two functions:
1. If it comes on while driving, it
indicates that one or more of your
vehicle's tires are significantly low
on pressure.
You will also see a ''CHECK TIRE
PRESSURE'' message on the multi-
information display (see page
Check the tire pressure monitor on
the multi-information display and
determine the cause (see page
If this happens, pull to the side of the
road when it is safe, check which tire
has lost pressure on the multi-
information display, and determine
the cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinflated, call a professional
towing service. For more
information, see page 513
2010 RL
Instrument Panel Indicators
2. If this indicator begins to flash,
there is a problem with the tire
79 ). pressure monitoring system
(TPMS). You will also see a
''CHECK TPMS SYSTEM''
message on the multi-information
425 ). display. The indicator continues to
flash for a while (approximately 1
minute), then stays on. If this
happens, have your dealer check
the system as soon as possible.
For more information, see page
423 .
.
67