Starting The Engine - Acura 2010 RL Owner's Manual

Your vehicle's starting system has an
auto control mode. When you turn
the ignition switch to the START
(III) position, this feature keeps the
engine's starter motor running until
the engine starts. Follow these
instructions to start the engine:
Apply the parking brake.
1.
2. In cold weather, turn off all
electrical accessories to reduce
the drain on the battery.
3. Make sure the shift lever is in
Park. Press on the brake pedal.
Without touching the accelerator
4.
pedal, turn the ignition switch to
the START (III) position, then
release the ignition switch. You do
not need to hold the ignition
switch in the START (III) position
to start the engine. Depending on
the outside temperature, the
starter motor runs for about 6 to 9
seconds until the engine starts.
If you hold the ignition switch in
the START (III) position for more
than 7 seconds, the starter motor,
depending on the outside
temperature, runs for about 10 to
25 seconds until the engine starts.
If the engine does not start, wait at
least 10 seconds before trying
again.
The immobilizer system protects your
vehicle f rom thef t. If an improperly
coded key (or other device) is used, the
engine's f uel system is disabled. For
more inf ormation, see page
2010 RL

Starting the Engine

5. If the engine does not start within
15 seconds, or starts but stalls
right away, repeat step 4 with the
accelerator pedal pressed halfway
down. If the engine starts, release
pressure on the accelerator pedal
so the engine does not race.
If the engine fails to start, press
6.
the accelerator pedal all the way
down, and hold it there while
starting to clear flooding. If the
engine still does not start, return
to step 5.
The engine is harder to start in cold
weather. Also, the thinner air f ound at
. altitudes above 8,000 f eet (2,400
151
meters) adds to this problem.
397