Acura 2010 RL Owner's Manual page 470

BOLTS
1. Use a Phillips-head screwdriver to
remove the two undercover bolts,
and remove the holding clip with a
flat-tip screwdriver.
2. Carefully push up the side under
cover into the bumper.
CLIP
CONNECTOR
Remove the electrical connector
3.
from the bulb by pushing on the
tab and pulling the connector
down.
4. Remove the bulb by turning it one-
quarter turn counterclockwise.
2010 RL
5. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
6. Push the electrical connector back
onto the bulb. Make sure it is on
BULB all the way.
Turn on the fog lights to test the
7.
new bulb.
8. Reinstall the two undercover bolts
on the side under cover and
tighten them securely. Put the
holding clip back on the side
undercover and push on the center
until it locks (the center is flush
with the head).
Lights
467