Turn Signals And Headlights - Acura 2010 RL Owner's Manual

Turn Signals and Headlights

Turn signal
1.
2. Off
Parking and indicator lights
3.
4. AUTO
Headlights on
5.
6. High beams
7. Flash high beams
Fog lights off
8.
9. Fog lights on
140
Push down on the
Turn Signal −
lever to signal a left turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Headlights − The rotating switch
on the left lever controls the lights.
Turning this switch to the ''
position turns on the parking lights,
taillights, instrument panel lights,
side-marker lights, and rear license
plate lights.
Turning the switch to the ''
position turns on the headlights. If
you leave the lights on with the
ignition switch released after turned
to the LOCK (0) position or when
the built-in key is removed from the
ignition switch, you will hear a
reminder chime when you open the
driver's door.
2010 RL
When the light switch is in the
'' '' or ''
lights on indicator comes on as a
reminder. This indicator stays on if
you leave the light switch on and
turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position.
To switch from low
High Beams −
'' beams to high beams, push the left
lever forward until you hear a click.
The blue high beam indicator will
come on (see page
to return to low beams. To flash the
high beams, pull the lever back
'' lightly, then release it. The high
beams stay on as long as you hold
the lever back.
'' position, the
65 ). Pull it back