Table of Contents
Advertisement
Audio System
SKIP (SEEK)
The skip (seek)
−
function searches up and down from
the current frequency to find a
station with a strong signal. To
activate it, press either side (
) of the SKIP bar, then release
it. You can also activate the skip
function (SEEK is displayed on the
screen) by pushing the interface
selector to the right or left.
SCAN ICON
216
SCAN
The SCAN function
−
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
or
then release it.
To scan with the interface dial, push
the selector down, and then push it
to the right. You will see SCAN
flashing on the screen and the upper
display.
The system will scan for a station
with a strong signal. When it finds a
strong signal, it will stop and play
that station for about 10 seconds. If
you do nothing, the system will then
scan for the next strong station and
play it for 10 seconds. When it plays
a station that you want to listen to,
press the scan button again, or push
the interface selector to the right
again.
2010 RL
Preset
Each preset button or
−
preset icon can store one frequency
on AM and two frequencies on FM.
To store a preset memory location:
Select the desired band, AM or
1.
FM. FM1 and FM2 let you store
two sets of FM frequencies with
the preset buttons (on-screen
icons).
2.
Use the tune, seek, or scan
function to tune the radio to a
desired station.
3.
Press the preset button, and hold
it until you hear a beep. You can
also store frequencies with the
interface dial. Select the preset
icon you want to store the
frequency on, then press ENTER
on the interface selector, and hold
it for more than 2 seconds.
4.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Advertisement
Chapters
Table of Contents
