Siemens SINAMICS GM150 Operating Instructions & Installation Instructions page 130

Operation
8.3 Operation via the AOP30 operator panel
Setting the date/time
In this menu, you can set the date and time.
1. Select the desired setting using the <▼> function key.
2. Change the setting using the numeric keys. You can delete incorrect entries using the <◀ C>
3. Select the "synchronization" row. Make the desired setting.
4. Select "Save". Confirm the setting with <OK>.
Extended settings
In this menu, you can make the following extended settings:
● Load the AOP settings from the CU
● Automatically acknowledge topology
130
function key.
– "None"
The AOP time is managed internally and is displayed in the upper right of the operating
screen.
– "AOP➙DRIVE"
The AOP time is recorded in the drive each time the AOP is powered up, and daily at 2:00
AM. If a valid synchronization is detected, the time stamp for faults and alarms is
displayed on the AOP in real time.
– "DRIVE ➙AOP"
This operating state requires that the drive be connected to and synchronized by a
master clock. Every time the AOP is powered up, and daily at 2:00 AM, the time of the
drive is adopted as the time of the AOP. If a valid synchronization is detected, the time
stamp for faults and alarms is displayed on the AOP in real time.
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE